COND=TIMED, DATAWIDTH=BIT1, STARTMODE=MANUAL, STOPMODE=CONTINUOUS
No Description
| TRACESEL | Trace Select |
| DATAWIDTH | Data Width 0 (BIT1): 1 bit 1 (BIT2): 2 bits 2 (BIT4): 4 bits 3 (BIT8): 8 bits 4 (BIT16): 16 bits 5 (BIT32): 32 bits |
| DATAROTATESIZE | Data Rotate Size |
| STARTMODE | Start Mode 0 (MANUAL): In this mode, setting CMD.MODE=CAPTURE would start the capture 1 (START_TRIGGER): In this mode, a start-trigger(via STARTTRIGCTRL) would start the capture |
| STOPMODE | Stop Mode 0 (CONTINUOUS): Capture will continue to occur until another mode is configured 1 (BUF_FULL): Capture will stop when the memory buffer is full. In this mode CAPTURESTOPDELAY has no effect 2 (STOP_TRIGGER): Capture will stop when the stop-trigger event occurs or optionally after a CAPTURESTOPDELAY number of cycles/capture-events if configured 3 (STOP_TRIGGER_FULL): Capture stops when either of the following conditions is met (in either of these conditions, CAPTURESTOPDELAY has no effect): BUF_FULL condition or STOP_TRIGGER condition |
| COND | Condition 0 (TIMED): Capture condition is based on the rate specified in CAPTURERATECTRL register within the active capture window 1 (START_TRIGGER): Capture condition is every start-trigger event in the active capture windo 2 (SLAVE): Capture condition is every cycle when cap_event_in input is high |
| STOPCONDPRI | Stop Condition Priority |
| WRITEDIS | Write Memory Disable |
| DATAOUTEN | Port Interface Enable |
| DATAOUTDSHIFT | Port Interface Shift |